Questions & Answers for: velodyne subwoofer power sound

...power on the subwoofer still comes on, but no sound will come out. Receiver settings are for a subwoofer to be connected. I removed the subwoofer speaker from the unit and hooked the speaker directly ...

...sound Will give bass for a short period of time, if I power it off on back on it will work for another short period, capacitor? overheating and powering itself down... will it stay on if you play it ...

velodyne sobwoofer has power but no sound is coming out In order to get sound from your sub you need three things: power, a cable to get the audio signal to the sub, and a signal from the audio source

subwoofer (volume, crossover, phase, etc.) been properly set? 6. If unit has been running at high levels, one of the protection circuits may be engaged. 7. Has the built-in amplifier overheated? http:

Velodyne SPL 800II began to distort for a few seconds when it first turned on. Often turning the power off and then turning it back on would correct the problem. In time, this solution became less and

subwoofer to the pre-amp out I have connected my Velodyne CT80 to the "mono out" on the back of my dolby 5.1 receiver. The subwoofer has worked for a few years but now is not working. The power on the

...subwoofer keeps poping and then stops working larryagross, Sounds like you blew the speaker! The amp is sensing the voice coil is connecting to the speakers magnet or iron core and is going into a ...

...power off and on to my entertainment system. Since then my subwoofer has been inoperative. It will not turn on with the amp any longer and no sound. I found the remote and the blue power indicator ...

...velodyne dd 10 subwoofer In 90% the cause of electrical problems with amplifiers in this kind of units is the self-healing factor of the very cheap capacitors and , most of the used capacitors have ...

minutes later the sub woofer had stopped no sound power light still on room speaker woofers were also gone mids and tweeters fine Check wiring for loose connection...may have to open speaker enclosure