Questions & Answers for: Harley Davidson vdc light

...the charging system. Here is a few tests you can run. First with the bike off take a multimeter in VDC check the battery voltage at the battery. (should be at 12.5 VDC) If not first charge the ...

...thanks gavin Here is a few tests you can run. First with the bike off take a multimeter in VDC check the battery voltage at the battery. (should be at 12.5 VDC) If not first charge the ...

...than 1 ohm you have a broken or poor ground wire. If resistance is less than 1 ohm check for 12 vdc on both sides of the accessory fuse. If you have 12 vdc to only one side, replace the fuse. If ...

harley davidson brake light not working check bulb check for 12 vdc at socket check brake light switch

...light came on and right before I got home I had lost all of my lights and battery power. What could this possibly be. first check your battery connections and make sure they are tight and clean. Then ...

...1200 c 5 wire hookup Orange/white = 12 VDC Blue = 12 VDC for tail light Red/yellow = Power from brake light switch (to stop light) Black = Ground(s) Purple = Left Turn Signal Brown = Right Turn ...

...will not start and engine light stays on. after sits awhile does same thing.plugs were replaced.battery was checked ok.voltage check while running was 12.6 vdc. fuel tap filter gummed up,lack of

...and turn signals. Orange/white = Switched 12 VDC (tail light) Red/yellow = Stop light Solid brown = Right turn signal power/signal Solid purple = Left turn signnal power/signal Solid black = ...

...light come on then go off. when i go to start it it just clicks and will not turn over. using a HD battery tender. could it be a fuse, stator or voltage regulator? more likely it's the stator. with a ...

...light glows at any time the regulator is defective (shorted) and needs to be replaced. OTHERWISE: Motorcycle voltage regulator connections must be clean and tight for proper operation so it must be ...