Questions & Answers for: Yamaha vdc

...An answer, but likely not a solution. I believe all Yamaha PSR series keyboards use the same 12 VDC adaptor, so I looked at the electrical schematic for another model I have. There seems to be no ...

is at the battery. with the battery fully charged and connected to the bike. get a voltmeter and in vdc place your meter leads on the battery terminals with the bike off. you should have 12.5-13.0 vdc

...Big Bear 400. It seems that the battery is not charging, but when I put on a charger it hold 12+ VDC. Lights get very dim in a short while. Is that relay bad and is it part of the charging

...Check on the regulator calls for checking the battery voltage when revving the bike (14.5 VDC). Good luck and thank you for asking FixYa. I have a 03 R1 & have went through a stator and ...

chargeing system only putting out 6 volts . is this the correct voltage? No, it supposed to be 12 Vdc or a bit higher. Check and fix your charger.

ybr 125 blowing headlamp lamps . voltage at lamp holder with lamp removed and engine running is 14.1vdc with lamp fitted ie under load is 13.4vdc . all connections ok and earth to chassis ok . but ...

(new) horn not working I have 11.85 vdc at horn connectors when ignition key is on and horn button pressed. I have .23 vdc at horn connectors when ignition key is on and horn button NOT pressed. When ...

no power. voltage converter putting out 13 VDC. ON/OFF switch works. Any suggestions? Inspect if the power input socket of The keyboard it may have a loose soldering or a cold one in one of the tips ...

...to check DC voltage ? You possibly could have the batteries hooked up wrong and not getting 36 VDC. Also did you replace with the same number (6) 6 volt batteries or three 12 volt

it won't start the problem is there isn't any spark Primary side of the coil should have 100 vdc.The stator should produce 100 vdc.The pick up should produce .7 vdc minimum. Check this out and you ...