Questions & Answers for: valve triac

valve, water distributor, wiring, main PCB,anti-overflow pressure switch E36- Water leakage (maximum number of resets exceeded) -Water leakage, drain hose too low, pressure switch,wiring, main PCB E40

...valve Triac closedlopen circuit - check valve/operation - machine drains until Level Switch resets+30" A11 = 1/2 load Solenoid Valve Triac or alternating Wash Motor action - check Solenoid Valve ...

of could it be defective Triac in the electronic control? i would look to the valve solenoid as the issue, if not the pressure from the incoming water supply( try decreasing under sink perhaps to high

...triac at control board, but when I replaced it - it damaged once more. I measured the resistanse of aquastop valve - 500 Ohm. It seems OK. Unfortunately I have no any schematic of dishwasher. If ...

Valve Triac' but as not an engineer what is that? and what parts are needed and or reset codes? hi the fill valve triac is the plastic vlave that the inlet hose connects to you can get them for about

...valve to see if the electronic is working. Don't forget to check that the voltage goes away when the cycle is on spin as the electronic triac could be faulty too. Hope you can get the idea what to do ...

...THEN IT IS THE SWITCH E32 relates to the electronic pressure switch, normal pressure switch,inlet valves,poor water mains pressure and finally the main control board E90 means theres a fault on the ...

fill valve is getting only 40 volts ac. the solenoid is ok and the level switch is ok. what could cause the low voltage? Bad triac on control board. Replace control board.

...dishwasher only getting 40 vac to inlet solenoid. why. Everything functions as should overflow switch working proper. fill valve works with 120 vac. Bad triac on control board. Replace control

...triac of the controller. Change the controller. (2) Does water fill even though it is not energized (power is off)? If the water fills, then you have a defect of the inlet valve, change inlet