Questions & Answers for: Nissan Hardbody valve king

Question about 1990 Hardbody King Cab

1 Answer

...off when driving over speed humps. any ideas what to check before taking it to a mechanic? The EGR valve sticking, loose wires, bad ground connections, dirty connections, fuel pressure dropping out, ...

Ad

...out what i have crossed my truck wont idle at all now that i have crossed them you crossed the egr valve hose most likely. there is a diagram on the underside of ...

Ad

Question about 1990 Hardbody King Cab

1 Answer

my 04 hardbody keeps cutting out wont start engine light flashing then next day it will be fine, untill the next time check the egr valve on it

Question about 1990 Hardbody King Cab

1 Answer

why does a fuel injected nissan v-6 3000 engine act like it's flooding? If i cover the air intake valve with my hand it will rev up but if i don't it will not. Hello! I suspect a defective Throttle ...

Question about 1990 Hardbody King Cab

1 Answer

what is the valve clearance and head bolt torque on a nissan td27 engine 1996 model valve clearance is .014 inch for intake and exhaust with engine warm. head torque it 21 ftlbs, then 44 ftlbs, then ...

Question about 1989 Hardbody King

1 Answer

...be primed turn engine over to release air ( No Smoking) then tighten lines. fuel rail might have valve, (looks like tire valve) if so it is recommended that air is relieved at air ...

...nesson pickup gas wont stop flowing through carb This will probably be caused by either the needle valve and seat being worn or damaged,or the float in the carb fuel bowl stuck or damaged so as to ...

...when trying to crank doesnt stop. Whats wrong This will probably be caused by either the needle valve and seat being worn or damaged,or the float in the carb fuel bowl stuck or damaged so as to ...

...key on the injector sprays to much gas that it run out of the throttle body what causes this check valves, ajust if needed tight intake valves or burnt intake valve can couse ...

timing belt isnt moving when i turn the main crankshaft This indicates a broken timing belt and will require the front of the motor to be pulled of to replace it . I suspect that you will have bent ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...