Questions & Answers for: Isuzu Axiom v6 isuzu cam timing

replacing a timing belt on 2002 izuzu axiom xs. Cannot seem to get it installed correctly. Vehicle will not run. Aligning all marks and number 2 cylinder is at TDC. Please help. how to replace the ...

I just had the motor tuned up and the oil changed....still quits when I turn right - sometimes. if V6 engine check wiring loom on left head to inner guard (pull and wiggle loom while engine running )

I have a 2006 Trailblazer ext ls, v6 and within the last week the fuel gauge is registering low or no fuel when I know there is a 1/4 tank or more. Please help! sending unit in the tank is bad. common

looking for serpentine diagram for izuzu axiom 2.3 V6 On all vehicles since 1984 the v-belt/serpentine belt routing diagram has been on the inside of the hood or on the radiator cross member.

...isuzu axiom that would keep from starting No. Check of faulted PCM. With car off, turn key to ignition ON, and do not crank. Look for check engine light to flash. If it does not, PCM is faulty. Also, ...

Isuzu axiom P0401 and p1312 codes driving me nuts. Plz help P0401 changed EGR valve and the passage to the intake mainfold was cleaned, but the problem still exists. It hesitates to move from stop and

...Isuzu Axiom. The directions said to rotate the crankshaft 6 revolutions and re-check the timing marks. The marks on the pulleys and housing lined up just fine but the 3 lines on the belt did not line ...

isuzu axiom are you kidding, is this your first day at car repair, are you 10 years old>>? that;s great but do say so , so we can drop to super basics.... my wild guess is you asked this because

is the 2002 Isuzu Axiom 3.5 v6 a non interference engine? no it is a interferance engine

V6 (gasoline) this is 4 cam engine , with belt. seen here http://jeepdied.com/look/alien-stuff/Isuzu/head%20cam%20sensors/6VE1-A.JPG THE BELT CAN SNAPs, AND FOR SURE those 2 cam valve per bank can not