...trying to scan something to my pc...i saw that "scanner failure was in the little window...i have unplugged everything...upteen times. troubleshooted till i dropped.Still no joy. I can print off ...
Question about OfficeJet D135 All-In-One InkJet Printer
scanner bulb is not moving, then its an hardware problem. We can try by resetting the printer. POWER DRAIN:-Turn off the printer, Unplug the power cable from printer and from the wall outlet.Press and
scanner light by trying to make a copy. Caution: do not look directly in the light 3. Perform a power cycly * Unplug the power cord from the product while its still on * Plug the power cord back again
Question about Officejet 6310 All-In-One InkJet Printer
...scanner failure. Also dialog pops up saying communication error. Any ideas? hi, that error message is nothing to do with the software part, it actaully hardware issue try the following, 1) unplug the ...
...SCANNER FAILURE" TURN POWER OFF THEN ON. When i do this it only fixes the problem for a short time then i get the same error again... Let's try this. Turn power off, unplug the cord from the surge ...
...scanner bulb is no longer working. There are a few things that can sometimes bring it back but it may be a permanent issue. 1) Make sure printer is directly into the wall and not a surge protector or ...
...scanner is removed. 2. Open the cartridge access and unplug the power when the cartridges emerge from the service station. 3. Remove the rear clean out door. 4. If there are any screws are in the ...
...UNPLUG AND PLUG IT BACK IN? THE SCANNER COMES WITH A CD INSTALL THAT CD AND WILL GO TO SET UP. THE SCANNER SHOULD WORK SOON THE SETUP IS DONE. IF YOU MISPLACE THE CD YOU CAN GO THE HP WEB SITE AND ...
...Unplug the Scanner cable from the computer. Unistall the Scanner drivers from Device manager and also unistall the all the Scanner appications restart the computer try to download drivers from the ...
Question about OfficeJet 6110 All-In-One InkJet Printer
...scanner-head is mechanically stopped but the step-motor is running very noisy until I unplug the power cord from the unit. maybe it is malfunction of the stop sensor, how can I check it? The problem ...
Usually answered in minutes!
2,817 Questions
1,584 Questions
1,223 Questions
991 Questions
857 Questions