...sound in headphones and amp. Likely a filter capacitor in power supply is failing if it has started doing this. SOMETIMES devices have a very small amount of hum normally. Also sometimes unbalanced ...
...headphone output seems fine to me, even though the channels appear to be blended across the earphones - I couldnt get left / right only out of it, even using the balance knob. However, with thr ...
...sound on every channel trough every output, I'm using unbalanced cables and running it trough a non humming berhinger powered mixer If the hum is observable in headphones, then it is likely a power ...
...unbalanced jack for plugging into an amp, mixer etc. Here is a link to the manual if you didn't get one:http://www.akaipro.com/ewi4000s/?tt=5 It is battery powered ( 4AA batteries ) so don't forget ...
...sound card. (not the microphone in ). The RCA jacks are hooked to two cords that I made up that have a RCA plug on one end and a XLR plug on the other. The XLR plugs are wired so that they are ...
Question about 2488 Portastudio Multitrack Recorder System
...sound what so ever i have my headphones plugged up to it but absolutely nothing...what am i doing wrong???...is there somethin i press to get general audio playback. hi Tascam Digital recording is an ...
...unbalanced cables for this. The user manual explains balanced cables and what they look like. I just repaired one of these mixers that some foolish people plugged stuff into the MAIN INSERT jacks and ...
Question about Mg102c Stereo Mixer
headphone jack gives me the hiss. Is there something wrong with my set up or my camera? It could be the type of cables you're using. Are they balanced or unbalanced? The jacks on the end will tell you
...unbalanced. A simple fix is a cheap headphone amp (less than 20 pounds) and a simple jack to two phono lead (wired as a split). There is a ton of old audio equipment about for very little money ...
Question about Eurodesk SX2442FX Ultra Low Noise Design 24 Input 4 Bus Studio/Live Mixer
...sound from my monitors. If i put the jacks full way in and leave the board, I get nothing. All this equipment is brand new. What I want to do is have my interface as a bridge or halfway point between ...
Usually answered in minutes!
297 Questions
191 Questions
155 Questions
161 Questions
136 Questions