Questions & Answers for: un jam sewing machine threading

...jam is free, then use compressed air or brush or vaccuum to rid the now dislodged thread. Other possible causes for non-operation include: raised presser foot and/or un-depressed or faulty start/stop ...

...machine (Kenmore 385.15243/15343) and the needle broke. I replaced the needle and cleared everything out. The feed dog was lowered and I fit that back into place. Now, when I try to sew, it works for ...

...pedal I get the same response. I used it just 3 days ago and it was working fine. Do you think it needs oil or what else may be wrong? open your bobbin case and un jam it thread wound around the ...

sewing. the top stitch keeps getting tangled in with the bobbin thread and jamming up the machine. Hello, Here are a couple of things to try. * Un-thread your machine and remove your bobbin. Clean any

sewing machine and begin to sew the cotton just bunches up and jams . Any suggestions Hello, Here are a couple of things to try. * Un-thread your machine and remove your bobbin. Clean any loose thread

...sewing on top. When I try to remove the fabric it is stuck and there is a mess of thread underneath. I have cleaned and oiled my machine and the problem is still there. I think my tension is fine. ...

...Un-thread your machine and remove your bobbin. Clean any loose thread or lint out of your bobbin case. Re-thread your machine, reinsert and re-thread your bobbin. * Change your bobbin. There could be ...

...sewing machine and either i cant figure out how to tread it or it just keeps jamming. how do i make it so it wont get jammed? Hello, Give these solutions a try. * Un-thread your machine and remove ...

un jam it but nothing is working. What happened was the thread was caught and it jammed. try rethreading the machine top and bobbin also try a new needle make sure that the top thread has not come off

un-threading itself. My thread is coming out of the thread take-up. It seems to be missing the thread guide as it is pulled through before being taken up to the thread take-up, or just coming out when