...solder (replacing them very difficult), both are labelled on motherboard so not too hard to find (f1 is below charging point and f2 is below that near bottom right hand slot type 1 port). if green ...
...type of model... Replace the switch for the L-Button on the systemboard. You must have good solder skills and the part. The part is available on the well known auctions sites. If in doubt, send it to ...
...get replacements or can it be done at all. thanks I have soldered on myself. Try ebay for spares type in"L2 inductors for nintendo ds" it should direct you to an american seller. Cost about £10.50
...type cable plugs into it. If you are not lucky, like moi, you have broken the flip up part of the connector, but this whole part can be replaced from as little $1 (US dollar), perform the following ...
...Lite motherboard are power inductor,need to solder back,if dont know where to get,maybe following page can help you ...
...ofva faulty adaptor. Otherwise F1 or F2 or both fuses may blown internally. These are smd type fuses and need to be soldered directly to the
...solder these very small parts (i.e fuse dimensions - 1.5 mm x 0.8 mm and the "L2" inductor dimensions - 2.5mm x 1.8mm x 1.8mm) The is a product called wire glue which is avaliable from ebay (located ...
...E-bay have a new card reader,which they say needs no soldering. Has anyone had experience of this type of
...complete slot will need to be replaced. If it is not a bent or broken pin, there may be some other type of blockage inside SLOT 1. If there is nothing wrong with the pins and there is no blockage ...
safe time and effort to buy a game cartridge on line, cheap few bucks, and solder it onto motherboard to fix your issue. Just look for game cartridge slot reader for your type of ds on eBay! Good Luck
Usually answered in minutes!
5,602 Questions
1,598 Questions
788 Questions
56 Questions
16 Questions