...You will need to change or have changed the two convergence correction amp IC's in this TV set. This is a very common problem with projection TV sets. seeing dble vision ...
tv convergence problem I have a Panasonic rear projection tv Model TX-51P400H which is now 5 years old. Upon turning on the tv recently the picture was out of convergence with three images on screen -
...TV will enter into the convergence mode and adjust the converge automatically (that's what it says.) TO ADJUST IT MANUALLY: Press MENU, and the press < or > until the PICTURE menu appears. Then press ...
...tv settings then goto the convergence section. Try to adjust the red and then the blue convergence. You should be able to move them up, down, left, and right. If you can't move them in all directions ...
Question about 57F500 57" Rear Projection HDTV-Ready Television
...TV. Convergence will drift normally on large screen projection TV's over time or through moving them. The Hitachi 57f500a has a feature called "Magic Focus" (pg 36 in your manual) which will auto ...
Question about Grand WEGA KDP-65WS550 65" Rear Projection HDTV
...will follow. The parts for this repair will run about $40-$60. Dan Ur convergence it dead.U know how to solders?Buy a convergence kit.These websites have it Tv repair World.com,Tv repair
...red and green images to fine-tune the picture. Note: The ability to change channels is disabled when adjusting the convergence options. The TV must be tuned to a usable signal to converge the
Question about AV-56WP74 56" Rear Projection HDTV-Ready Television
...problems,it dead.The tv convergence board the 2 STK Convergence ICS and some or all it resistors must be replaced to solved the convergence problems.The shop will cost u $300-350 for parts and
...dead.The tv convergence board require 2 STK convergence ICS and some or all it resistors to be replaced to solved the convergence problems.The shop will cost u $300-350 for parts and
Question about HCM5525W 55" Rear Projection Television
...tv convergence board have dead 2 STK convergence ICS and some or all of it resistors too.These parts,must be replaced on the tv convergence board to fix the tv convergence board to solved the tv ...
Usually answered in minutes!