Questions & Answers for: turning on zone 2 speakers

...was switched off. Disconnect the speakers on Zone 2 and try to turn on the receiver again. If the receiver works, there is a shorted speaker wire, pinched wire, or a blown speaker on zone 2. Good ...

Ad

Question about RX-V2500 Receiver

1 Answer

...speakers? go into your amp settings menu then to speaker settings,set zone 2 on and main on, turn up the volume for zone 2 about half way then connect phono cables from zone 2 pre out to a input on ...

Ad

Question about RX-V659 Receiver

1 Answer

...speakers connected to Zone 2 regardless of the source. We could hear iTunes from the source in the primary zone, but we could get nothing from Zone 2. I've read the manual, but I'm basically at a ...

...Zone speakers work. They work at all times, with or without the Zone 2 button pushed 'on'. It's like the system doesn't recognize there is a Zone 2 at all. I get no help from the manual. Is there ...

Question about AVR-3805 Receiver

2 Answers

...avoid diverting the signal to the Rec Out jacks. Keep turning the input select button until it reads "Zone 2 Source". Then turn on and this should route the signal to your Zone 2 speakers. ...

...not reconnect the speakers to zone 2 speaker connections and make sure you do not have more than 4 pair of speakers with impedence matching volume controls or a impedence matching speaker selector ...

Question about TX-SR804 7.1 Channels Receiver

1 Answer

...zone 2 speakers, make sure wires are separated then reconnect at the receiver and test again. If it still stays on, Your receiver is good, your wires are good, you need to connect one speaker at a ...

Question about SR5005 Receiver

1 Answer

zone speakers into the SURR BACK/AMP ASSIGN speaker outputs on the unit. 2. You need to "amp assign" the speakers to zone 2 by pressing AMP, MENU, select SPEAKER SETUP, AMP ASSIGN and scroll to ZONE 2

Question about TX-SR576 7 Channels Receiver

1 Answer

off when i try to turn on the zone 2 (i have speakers wired throughout the house on zone 2). it plays normally when just playing in zone 1. Well, duh, check out the speaker wiring in Zone 2 for shorts

Question about TX-SR576 7 Channels Receiver

1 Answer

turning on the processor or where to wire the speakers to the receiver. to set up a zone 2 or zone 3 set up you need the yahama amps that receive the signal from the main amp, and from that zones amp,

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5755 Answers

SmartAviator
SmartAviator

Level 3 Expert

1124 Answers

Cindy Wells

Level 3 Expert

6688 Answers

Are you an Audio Players & Recorders Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...