Questions & Answers for: Oldsmobile Cutlass Ciera turn single

Question about 1989 Cutlass Ciera

1 Answer

turn single TURN SINGLE BLINKER SWITCH WHERE IS IT LOCATED AND WHEN I TURN THE TURN SINGLE SWITCH THE LIGHT STAYS ON IT DOESN'T BLINK You might have your wires attached wrong.

Ad

...turn? please help! I think because im a single female im being taken advantage of! I HOPE THESE TIPS CAN HELP YOU MOSTLY WHEN A STARTER TICS IS A LOW BATERY VOLTAGE BUT IN SOME OTHER CASES IS THE ...

Ad

...single one of them would have a fuse box. Engineering rules the fuses must be as close as possible to the power source which is the battery. Now you have main fuses which may also be called fusible ...

...turn signal it just stays solid.? most likely one of the bulb ons left side is burned out. Replace the burned out bulb and it should flash. you have a wire touching , a bad multifunction switch ,,, ...

...turn over. I put a new fuel pump on it and it still didnt have fuel pumping/going to the fuel rail. There's a single red wire on the passenger side of the car in the engine bay next to the passenger ...

...turn up and down for bright and dim to off position.'There may also be a single thumb turn or twist turn light switch that controls the interior lights located on or around the headlight panel

Question about 1993 Cutlass Ciera

1 Answer

...oldsmobile cutlass supreme sl, were would the turn single flasher be l- ocated at? according to autozone.com: Front seating area, driver side, under dash, mounted on passenger side of steering ...

fuse blow when i push on brake.turn singles still work Sounds like brake light switch is bad. It's mounted just above your brake pedal under the dash. They're plastic and break in occasion. Simple fix

Question about 1992 Cutlass Ciera

1 Answer

...a window disable switch next to the driver's side controls, check to make sure that wasn't turned on.If that's not it, check the fuse.If the fuse is good. Are all four windows not

Question about 1992 Cutlass Ciera

1 Answer

turn off on a delayed feature. I s there some sort of relay or resistor that is shot it could just be that the door switch is stuck,, most have a little rubber cap on them,, and come out with a single

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...