Questions & Answers for: GMC turn signal lever

...is for the turn signals and high beams and sometimes cruise control and windshield wipers. The combination switch is the turn signal lever. Also might want to check turn signal flasher

Turn Signal keeps clicking I have a 2000 yukon xl and the turn signal noise keeps clicking after I use the turn signal. The lights work fine on turn signal and hazards but it just keeps clicking long ...

...turn signal flasher relay, very cheap part (around $2) and can be bought from just about anywhere that sells any type of auto parts. Also check your fuses. If replacing the relay doesn't remedy your ...

...turn signal control lever part # 26100837, i need to know if this will fit my 2001 Denali.Mine has everything on this lever. Wipers,turn signal,washer,cruise control. Maybe? the older trucks you just ...

...turn signal lever by slightly rotating the outer end of the lever then pulling straight on the lever. ?Peel back on the foam shield from the turn signal switch then disconnect the turn signal switch ...

turn signal not working but flashers do what is it Most common problem is the combination/multifunction switch (the turn signal lever), I'd be willing to bet that's your problem. I've run across it ...

hand signal .you flick the turn signal lever and sometimes it will start to work properly!!!! You will need to replace the turn signal switch assmbly, it is defective, nothing else causes this problem

Turn Signal Lever is Loose The turn signal lever on my 1994 GMC Jimmy flops up and down instead of locking in place when I try to signal. Is it simply the turn signal switch/lever that needs to be ...

...turn signal, the hazards come on instead. Solutions, answers? When you touch the turn signal lever do you hear clicking noise befor u lift up or down if so then could be bad turn switch or just bad ...

...turn signal switch now I lost my four wheel drive. Are they connected? Drive shaft to front turns but no light, floor lever control. No, there not connected to each other. Unplug the switch and plug ...