Questions & Answers for: turn dial control dryer

...turn on when the power button is pushed. but i noticed the heavy duty light on the dial stays on unless I unplug the machine. we have already replaced the control board and had a technician out that ...

...turn the dial) the selection dial stops working frequently you need a new timer....it is actually a plastic disc that goes under the outside dial....sounds like a few of the teeth may be broken off, ...

dial does not turn to stop automatic turn whirlpool dryer on any setting it drys but the dial does not turn for the timer to stop when finish Hi, You will need to change the timer. The timer motor has

...dries but doesn't turn off Check for bad motor timer. Attached to dial control. Test by turning dial to timed position without starting dryer. Dial should return to off. Timer is available

...dial moving as dryer runs? If not, may be a bad clock motor on the timer body. Is this an auto-drying cycle--bad air-outlet temp sensor. If computer controlled timer, does it display any error codes ...

Maytag Dryer Cycle not Turning My maytag dryer's cycle is not turning. There is heat but the cycle is not turning. if ther is heat, and the drum is spinning, the dial/control mechanism is faulty

...turn right dial to point to the "white sausage" at the bottom of the dial; Turn middle dial to 90 mins, or so; (Left dial only controls "Spin" speed - just set to max); and close the door. (It should ...

turn the dial and it does not start. This sounds like a possible issue with your door latch or control panel. I would recommend for you to check the door strike and door latch to make sure there is no

dial seems to get me better results, but when I turn it quickly there is no telling where the selector light will stop. All other buttons on the control panel work properly and I get no error messages

...Turn the dial to off. Then you need to press and hold the start button and the low heat button. Keep them both held in and turn the dial 1 click clockwise. Keep the buttons held in till start light ...