Questions & Answers for: turbochef tornado 2 f3 mag

2 minutes, replug and press "oven on" key If the problem comes back the micoware needs repairs, contact your dealer or turbochef it has a problem with its timer plus the tempratuture controller sensor

turbochef tornado this one gives f3mag current error allt he time, and most of the functions work. but it quits before finishing cooking.saying "remove food!" F3 errors can indicate a mag problem. ...

...F3 Mag Cur code? I have the same problem - just started happening tonight. How did you fix it? Thanks - NIck Yager [email protected] There are 2 mags in this oven yo have to figure out which mag is bad ...

...Turbochef Tornado Hi there. Today I was fixing the door on my turbochef tornado. The door screw was broken. i successfully changed that. Everything was working perfect after it was done. Then after 2 ...

...2 high voltage transformers. inspect them for burn marks. These are one of the causes for an f3 fault if they look excessivly burned up replace the bad one. Turbochef sells those for around $150 also ...

F3 code I have replaced 2 high voltage transformers,2 caps,2 mags,2 lo voltage transformers, 3 relays, and I/O board. and still have a F3, i have reprogramed the I/O board twice and my amp clamp reads

...F3 MAG CURR means you have a problem with the high voltage system in your oven, the microwave circuit. The next part is extremely dangerous, if you have no background in electric STAY OUT. CALL A PRO ...

...F3 errors can indicate a mag problem. Did you replace both mags? It can also be a door switch. If your fuses are good, you need to inspect the 2 magnetrons. If you have a burned tip on one the ...

...F3 MAG CURR" error message, and oven shuts off early Its a big pain in the *** issue. IF YOU KNOW HOW TO USE CLAMP AMMETER THEN ONLY YOU CAN USE MY METHOD TO TROUBLESHOOT IT. MAKE SURE OVEN HAS ...

...tornado 2 (hgc) after 1st use f3 curr mag code, go figure, took it to authorized repaired center they just called and gave me estimate for for repair which I did, it was "the transformer and fuse" my ...