Questions & Answers for: Dodge Stratus turbine shaft speed sensor

transmission problem 97 dodge stratus, automatic transmission, have PO700 and PO715 generic code. P0715 - Input/Turbine Speed Sensor Circuit Malfunction P0700 - Transmission Control System Malfunction

How do I change Transmission Turbine Speed Sensor on a 2001 Dodge Stratus? hi the tss is in the front wen you open the hood on top of the solenoid pack it screws off turning it counter clock wise.

...turbine speed sensor and the shaft speed sensor on a 2001 Stratus R/T Coupe? look on the tranny,especially near where either axle enters the transmission. most likely they will have a 2 wire plug ...

where is the crank shaft speed sensor located on 2001 dodge stratus 3 liter engine right top of the transmission bell housing

...Turbine Speed Sensor and the Output Shaft Speed Sensor. The cost to replace either of the Speed Sensors is estimated at $25.60 for parts and $32.50 for labor. All prices are estimates based on $65.00 ...

location of output shaft speed sensor on 2000 dodge stratus Behind front wheel cover on drivers side of car.

...turbine speed sensor? I have the R/T v6 3.0L Coupe MAKE SURE YOU IGNITION KEY OFF POSITION. YOUR VECHICLE SPEED SENSOR IS LOCATED IN THE INPUT SHAFT HOUSING NEXT TO TWO FLUID COOLING LINES TO REMOVE ...

where to find the output speed sensor Hello loverboy6210, The output shaft speed sensor is on the of the transmission. See The pictures below. I hope this helps. Regards, netvan

...You might try a new input shaft speed sensor first. If that doesn't fix it you may need a new transmission controll module or a new transmission. Start with the cheapest first as listed

...electrical connector to the wiring harness connector. Attach connector to heater tube bracket. Install speed control servo. Tighten nuts to 9 N·m (80 in. lbs.) torque. crank shaft position ...