Questions & Answers for: Dodge turbine sensor

transmission problem 97 dodge stratus, automatic transmission, have PO700 and PO715 generic code. P0715 - Input/Turbine Speed Sensor Circuit Malfunction P0700 - Transmission Control System Malfunction

...turbine speed sensor is located just behind the bell housing area of the case. I believe the trans controller is the only module that needs that info. The Crank Position Sensor give engine RPM info ...

...turbine speed sensor and the shaft speed sensor on a 2001 Stratus R/T Coupe? look on the tranny,especially near where either axle enters the transmission. most likely they will have a 2 wire plug ...

...turbine speed sensor? I have the R/T v6 3.0L Coupe MAKE SURE YOU IGNITION KEY OFF POSITION. YOUR VECHICLE SPEED SENSOR IS LOCATED IN THE INPUT SHAFT HOUSING NEXT TO TWO FLUID COOLING LINES TO REMOVE ...

...Turbine Speed Sensor Circuit Malfunction The service manual does not list P0751 as a valid code for your vehicle. You may want to re-check it to make sure you are reading it correctly. Also note that ...

...caravan It depends on WHICH speed sensor you are talking about. Your vehicle is equipped with 6 of them. One Vehicle Speed Sensor, One Transmission Turbine Speed Sensor, and Four Wheel Speed

turbine input shaft speed sensor circuit where is it located both input and output speed sensor are located on the left side of the transaxle case. do not interchange input and the output sensor.

...but the car wont shift. Any suggestions? Check for codes, may have a bad speed sensor either input(turbine) or output (vehicle) speed sensor. They are a common problem with the Chrysler

...P0715 Code Defective Input/Turbine Speed Sensor Defective Shift Solenoids Defective Engine Coolant Temperature Sensor Defective Valve Body Dirty transmission fluid that restricts the hydraulic ...

How can I change the input turbine sensor on a dodge caliber '08 se 2.0 L n where's located exactly that sensor I suggest repair manual try filepeep.com or manualslib.com