...section (we live in an area prone to regular power outages) as it's an absolute shocker to reprogram. The other day, I noticed an item in the manual to say that it's supposed to hold its memories for ...
...section. When I select Tuner or VCR or any other input source that is connected to the receiver, the TV/DBS audio comes through the speakers too. Only by turning off the cable box will I get the ...
...My problem is, the few codes provided with the Motorola remote for Yamaha audio amps/audio amp tuners do not work and there are no Yamaha codes for the Home Theatre in a box section. So, I am ...
...section is a couple of ICs (LAxxxx or LCxxxx). I will look this up when I get back to my shop. Check in the tuner area for a coupld of 14 pin ICs. Check for 12V or 5V in the area and look for poor ...
...any fuses need checking or any other ideas? This only a cold solder symptom in tuner section .Just reworks all solder joints components parts in tuner section. Good luck: Regards: Dont forget to
Question about NP 30 76 Key Lightweight Digital Grand Piano with Touch Response
section of the keyboard so I feel that something is worn out. I've worked on regular piano before but I haven't attempted to look inside of this one. Is this something that an ameteur could fix? I don
...tuner sound OK No sound from Satellite or Blue ray???? what audio cable type are you using, if its digital, you might have to assign that digital audio input with the video signal? go back over your ...
Question about Rx-v465/rxv465 Home Theater Receiver
...tuner plays, so the amp section of the Yamaha is working fine. The manual isn't the best, but I may be missing something regarding programming it. Also the test tone is working OK (Setup / Speaker ...
Question about Rx-v465/rxv465 Home Theater Receiver
Tuner, no sound. IPod, no sound. Phone was hooked up in multiple inputs. No sound. I'm stuck here. Please help. It sounds like the Yam can switch video sources but the audio amplifier section is dead.
Question about HTR-6090 Receiver
tuner check the speaker/s. If found OK; check and replace the damaged component/s at its audio output section circuit board. If needy, replace this board as card basis. If you wish to get some details
Usually answered in minutes!
192 Questions
173 Questions
140 Questions
146 Questions
92 Questions