...start the cycle then stop about a minute later. The pressure tube switch tubing gets clogged on these machines. The best way to repair is remove the 4 torx screws securing the control panel, On the ...
start, the washing machine fills, stops, rotates one way, rotates the other way and then starts filling more. It repeats that cycle until it eventually beeps. I've recently moved homes. Check the fill
...start the next cycle. It's a switch either in the control panel or at the top of the tub with a small tube connected to it which goes down between the inner and outer tube. As the water level ...
...start the next cycle. It's a switch either in the control panel or at the top of the tub with a small tube connected to it which goes down between the inner and outer tube. As the water level ...
...start the next cycle. It's a switch either in the control panel or at the top of the tub with a small tube connected to it which goes down between the inner and outer tube. As the water level ...
Question about 24032\24036 Top Load Washer
...start the next cycle. It's a switch either in the control panel or at the top of the tub with a small tube connected to it which goes down between the inner and outer tube. As the water level ...
...start. . This tube can get clogged and the switch won't work. Remove the tube and clean it out. Blowing on the tube when it's still connected to the switch will make the switch if it's working and ...
Question about LCE4332P 2.1 cu. ft. Top Loading Washer
...no water open the panel where all the bottons are and you will see a switch that has a clear hollow tube going to it,pull the tube off and blow into the clear tube as well as the switch,replace ...
Question about LCE4332P 2.1 cu. ft. Top Loading Washer
start the motor. However, if I take the plastic hose off the switch and blow into it, the motor starts fine. I've replaced the air switch with a new one, but with like results. Any suggestions
Question about LCE4332P 2.1 cu. ft. Top Loading Washer
Is someone able to help diagnose and troubleshoot an issue with my preamp? It is a Tube Works Blue Tube RT-904 I am getting pre-amp distortion/volume abnormalities still after replacing the tube (one ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions