Questions & Answers for: ts 420 Saws

Ad

Question about Ts 410 420 Cut Off Saw Decompression Grommet

1 Answer

...ts 420 does not start easily hi there; my stihl ts 420 does not start easily and it shut off by itself after 5-10 mins work. thank you; masoud replace the decompression valve. also check for carbon ...

Ad

Question about Ts 410 420 Cut Off Saw Decompression Grommet

1 Answer

...ts 420 saw? It's just spinning in the plastic, and what real German would use plastic anyway?! I need some tips please-geoff from PA I HAD THIS SAME PROBLEM. REALLY NO GOOD SOLUTION.. I WAS ABLE TO ...

Ad

Question about Ts 410 420 Cut Off Saw Decompression Grommet

1 Answer

where is location of serial number on a 420 stihl cut off saw? The Serial is engraved into the aluminum right next to the muffler. Look from the top down and you will see it. Good luck

Question about Ts 410 420 Cut Off Saw Decompression Grommet

1 Answer

hi,my stihl ts 410 saw cuts out after about 10 minutes work,it restarts soon after then cuts out after about 10 minutes again? any ideas,thanks dave Sounds like an overheating problem. Are you working

Question about Ts 410 420 Cut Off Saw Decompression Grommet

1 Answer

how do i remove the clutch from a ts 410 It should be threaded to the crank. On the end of the clutch it is hex shaped. I always used a metric socket and impact to pop them off. I am pretty sure they ...

Question about Ts 410 420 Cut Off Saw Decompression Grommet

1 Answer

...ts 420 concrete saw screws will not come out to replace air filter I'm trying to replace the filter on my stihl ts 420 asphalt saw and 2 of the srews just keep turning. I took some of the ...

Question about Ts 410 420 Cut Off Saw Decompression Grommet

1 Answer

how to refit a coil spring in a 420 i used a bench vice and has someone help me put it back in

Question about Ts 410 420 Cut Off Saw Decompression Grommet

1 Answer

stihl ts 400 has stopped working and sounds rough when pulling the cord Sounds bad, the only answer here is to pull the cylinder off and check the condition of the internals, if there is a lot of dust

Question about Ts 410 420 Cut Off Saw Decompression Grommet

1 Answer

ts 410 won't start check for spark, check for fuel, if you have both poss pot and piston

Question about Ts 410 420 Cut Off Saw Decompression Grommet

1 Answer

...the 410 is a little lighter, but what are the other differences..if any? maybe here. ...

Not finding what you are looking for?

Categories:

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...