Questions & Answers for: true freezer evaporator fan run

TRUE under counter FREEZER TU2-27F Freezer will not freeze water, gets cold enough to freeze the top layer of water, but not all the way through. I've checked and topped off the refrigerant and have ...

...freezer will not turn - no cooling - compressor fan underneath is turning The fans are controlled with a clixon that has a cut in at 5 degrees, and cut out at 20 degrees. If the unit is running and ...

true tuc 48 f temp not consistant ranges from -5 to +20 run ok otherwise Make sure condensor (outside) fan and evaporator (inside) fans are running smoothly. make sure no ice is develping on any parts

freezer cabinet is not cold 65 degrees evaporator fan does not turn on,condensor fan on,sttill no cold If you have just turned it on it takes awhile for the fans to come on. The evaporator coil has to

...freezer has power, but the fans are not going on when the door shuts and the temperature is rising. The defrost termination/ fan delay control is a temperature-activated, single pole-double throw ...

True freezer T-35F shoudl it be running hard all the time? Freezer motor seems to be running at full blast constantly. Have had to have it serviced a couple of times already. What else should we be ...

...True T49F Freezer I have replaced the capacitor switch. The motor runs but the fan in the top of the box doesn't turn on There is a switch above the door; check you have power from it when ...

evaporator that stops the fan running until the coil gets below -11c This can take some time after startup. if the freezer runs more than an hour before the fan starting, check the klixon isn't faulty

True gdm35 evaporator fans not working? Compressor running but not cooling. Evaporator fans not spinning?? change the fan motor, if the fan dont wonrk wont spread cool air

True 49f fans stopped running. Compressor still runs. Fixes? Troubleshooting steps? I am assuming you are relating to the evaporator fan(s) not running. If this is the case, some units have a 'Klixon"