Question about Memory Craft 9000 Computerized Sewing Machine
Husqvarna Viking 1050 Sewing Machine Motherboard My wifes machine begins its startup sequence but then goes dead. After a few minutes, the process can be repeated with same result. Seems/acts like ...
...lever located up and to the left of the needle bar. Pull it ALL THE WAY DOWN so that it will be tripped by the buttonhole foot as it moves. Set the stitch width to about 4 or 4.5. Set the stitch ...
Janome Memory Craft 4800 problems! Hi I have a Janome Memory Craft 4800 which has just started playing up. When I switch it only says Bobbin Winding on the screen and I can only use the stitch it was ...
Question about MyLock 634D Mechanical Sewing Machine
how to fix the timing janome overlocker 184d Thanks for your question! I'm sorry that you haven't received an answer yet. The response rate on FixYa FREE questions is usually over 80%, but sometimes ...
Question about Memory Craft 10000
error message asking to lower feed dogs before embroidering, feed dogs were lowered I selected an image to embroider, an error message came up to lower feed dogs, the feed dogs were lowered. I ...
consumer complaints I have a 350E machine bought for me as a xmas present 2013.after a month it broke down janome has told the dealer it could take up to 8 weeks to get the part .as I live in the ...
Question about Memory Craft 9000 Computerized Sewing Machine
How do I fix the following problem with my Janome MC9000 sewing machine? When I turn my machine on, after a couple of seconds I get the following error code appears on the screen: "Raise presser foot ...
How to clean/oil Janome Memory Craft 10000? This is the best I can help you for this device I am not sure of this but looked into it found nothing but your BEST bet is to contact the company directly ...
Question about Memory Craft 10000
My Janome 3/4 seems to have seized. It was working fine and the seized I can only move the needles a little with the manual wheel. Any tips first I would be checking for threads and fluff jammed ...
Question about MyLock 204D Serger NEW MyLock 204D Serger
I have a Janome Mylock 334D It stitches well, but starts clunking when run fast.Is this is a big problem or do I dump it. It was a good serger for many years but stored it when moving. The noise only ...
Usually answered in minutes!
565 Questions
193 Questions
102 Questions
90 Questions
79 Questions