Questions & Answers for: tripod head

tripod head from the rest of tripod? I don't know how to unscrew the SLIK tripod head from the rest of the tripod. Below the tripod head you will see what looks like a "sandwich" of two chromed pieces

tripod head I cant get the head for my tripod to unscrew off the tripod itself? Not all tripod heads will come off the tripod. some are made on the tripod so if you remove the head, you will have two ...

...OF EFFORT TO SEPARTE THE HEAD FROM THE TRIPOD. MAKE SURE YOU REMOVE THE 3 LITTLE SCREWS FROM BELOW THE HEAD, AND MAKE SURE THE TRIPOD AND HEAD ARE NOT COLD. IF THEYA RE WARM THEY WILL SEPARATE

...tripod head is stuck to the tripod. help! note: i have the manfrotto 503hdv head, and the legs are actually manfrotto 055CXPRO3 i have tried tightening the head controls. i have tried WD40 lubricant. ...

...head. The tripod has a standardized screw for accepting a tripod head, which is a larger screw than for the tripod mount on the camera. There are a variety of heads available, ball heads, three-axis ...

tripod=3/8 head = 1/4 need mounting plate 3/8 female to 1/4 male tripod = 1/4 head - 1/4 nothing tripod 3/8 head 3/8 nothing' tripod 1/4 head = 3/8 there is an adapter/reducer that screws into the 3/8

...tripod The head is mounted on the base by a 3/8" screw. The head is held in place by 3 set screws in the base. Turn tripod upside down, loosen (or if completely removed, do not lose them) those 3 ...

head would fit my tripod Most tripods have a standard screw on top. This allows users to mix&match tripods and heads. Thus, just about any head should fit your tripod. If you're not sure, take

...I release a Manfrotto 501HDV head from a tripod Tip the tripod upside down, on the bottom plate where the head attaches there are 3 screws... they need to be loosened, and then the head will spin

...is ideal for tripod mounts, take the tripod head off the tripod, and line up the 1/4 tripod head and camera and screw in the tripod head into the camera (bottom), if any questions contact me ...