Questions & Answers for: Hyundai trim tech spares

...type only) Remove the rear door inside handle housing. Remove the mounting screws (3EA) from the trim fasteners and the door trim panel to pry off. Disconnect the connector. Insert a trim panel ...

...and the rear view mirror. 3.Remove the front door inside handle housing. 4.Remove the front door trim panel. 5.Insert a trim panel remover between the trim fasteners and the door trim panel to pry ...

...hyundai santa fe? what should i be looking at to cause the code? also when is the long term fuel trim used? I'm not quite sure about the code in Hyundai's case but it definitely relates to fuel ...

...was rusted and broken that caused it. To get into the door I cut a 100mm round hole in the door trim from the inside with a jigsaw, (take off the opposite 'opening' door's trim to see where to

...them? I have a 2004 Santa Fe that had a similar rattle on the luggage racks. What I found was the trim at the front of the drivers side rack was a little loose. I added a small amount of black trim ...

...pressure regulator I have to check the evap system. Firstly, these codes are set when the fuel 'TRIMS' are out of spec (either tool LEAN - P1123, OR too RICH - P1128). The air/fuel control

...to dry them, but did not found how to do it. Thanks. try applying silicone around the rear window trim, this a common

...dash and recreate the problem. 1- Remove the ashtray and the 2 screws behind it. 2- Pull the lower trim gently. (You don't have to disconnect all the connectors.) 3- Remove the 2 screws that holds ...

...system also. Replacement of the window by self is not more complicated. You need to remove the door trim panel and other electrical connection from the doors. Then clean the busted debries from the ...

go between trunk and the hard liner. How can I get it out? Try a magnet If it is behind the plastic trim inside the trunk and you can see them, a wire hook might reach it and hook it out. If you can't