Question about Konica Minolta Office Equipment & Supplies
...tray for paper.... if not do the folowning power machine off from main switch sould be on the side or open the front door it;s on bottom left side.hold down the utility botton while powering on keep ...
Question about Konica Minolta Office Equipment & Supplies
tray can't lift. so check for anything jamed inside down there. As to reset the code open then close the front door where you put the toner. Turning the machine on and off will not reset the code. but
Question about bizhub C351 All-In-One Laser Printer
...open the tray and check the paper tray and checkthat the paper is loaded correctly pull all the paper out of the tray and check to see if any is folded or crumpled if the paper is ok it could be the ...
Tray will open automatically. 2-If the 3rd large tray cabinet is not opening then turn around the machine, at the back side of the 3rd tray, you will see a small hole downside at the back of the tray.
...Open the tray and make sure the paper is loaded correctly. The paper should be touched on all four sides by the tray or by adjustable guides. Open and close the front door with the tray out. Once the ...
...Open the tray and make sure the paper is loaded correctly. The paper should be touched on all four sides by the tray or by adjustable guides. Open and close the front door with the tray out. Once the ...
Open tray 1, check and make sure paper is loaded correctly. With tray open, open and close front door. This will reset error code. With tray 1 open look to see if paper is stuck behind tray in back of
...tray open an inch or 2 and turn the main power switch off then back on. The main power is on the back of the machine NOT the one on the right edge of the operation panel. Once the code has been ...
open tray one remove the paper that might be stuck behind it.. Then enter service mode utility/counter, touch details on the meter count, then stop 00 stop 01 then select system 1, then select problem
Question about Bizhub 362 Copier
TRAY 1 WON'T OPEN AFTER LOADING PAPER I was loading paper into the tray and when i went to print it came up with an error code (which has now disappeared so i don't know what it was) Now the tray will
Usually answered in minutes!
1,023 Questions
924 Questions
417 Questions
321 Questions
302 Questions