Questions & Answers for: Jura Capresso Impressa tray blocked

...it for a minute, but, you dont even need to do that i dont think. 1st open the tap. next insert the tray only (without the drawer) into the machine. The machine will say shut tap and then will begin ...

...tray at the front of the machine. Look inside and you will see a rubber flap which separates the right and left side of the machine. Gently lift this to the right and look inside to the left (a small ...

...stream of water from it, even when the machine is off. Most of the water is coming down into the tray. Can I fix this? run vineger through it or CLR before they plug up completly. good luck If you ...

tray completely, and place you hand in the cavity that it normally takes up. moving you hand slowly in, feel towards the top. you will find a little flap, past that flap there is the tamper and coffee

...blocked. To unblock remove tray, where the tray was insert your hand, with the palm facing up, then when the fingers touch a flap, just past that flap is the filter. Take a lint free or micro fibre ...

tray. The manual feed of ground coffee works fine, so all else seems OK. Thanks in advance! Usually water in the grounds container is caused by the coffee solenoid valve return side being blocked from

...blocked. Is it bi-passing the water into the waste tray. If so then you,ll have to repace the seals in the bi-pass valve positioned in the bottom of the brew unit. May also be a blocked thermoblock ...

...(using cleaning tablet) it made some strange sounds and the screen reads "Fault 8" - I removed the tray and cannot re-insert it as the mechanism (that possibly measures the coffee ground level?) ...

...tray is just emptied and cleaned Hi Shoba Photo sensor or switch is blocked. Not sure if yours is an Infra Red beam or switch Clean & inspect with flashlight Look for light path (blocked) or ...