Questions & Answers for: transmission shifts hard traffic

...it's low the shifter will be hard to shift even with the clutch in. For an automatic transmission, check your transmission fluid, and if you can, do a transmission filter/gaskit service. Good

...shifts smoothly under normal driving --- if there is stop and go traffic, however, within a few minutes of that, it will start shifting very hard again. Any ideas? Thanks. A reason for hard shifting ...

...transmission. This has got to be something fairly simple. It shifts fine under load with the gas pedal depressed. Let off the gas pedal and let it shift coasting and it will make you think the trans. ...

...hard time believing that. Perhaps I am missing something, but to me, 0 psi implies that no transmission fluid is flowing and that should mean that I should be seeing some severe shifting problems and ...

...shifts *hard* into second gear but will not shift any higher. This morning, the car stalled on me at a traffic light. The speedometer still does not work. Check the output sensor on the transmission, ...

...hard every time I get on a highway and come back to street traffic. I replace all 4 solenoids on the transmission and the problem still. can someone help me find out what is happening. thanks check ...

...transmission shifts, it generates a little heat. Normally that heat is dissapated through the cooling system, but if the transmission keeps shifting in and out of overdrive, expecially in heavy ...

...hard around 40-45mph but will run fine after that. Really don't want to have to replace the transmission if that can be helped. Suggestions? that is your ttc solenoid . it is your torque ...

...transmission such that you are at a higher rpm (2000-2500) then take your foot all the way off the throttle, if it is in lockup your engine rpm will stay about the same, if not it will go to about ...

transmission shifts hard into 2nd and 3rd and has a p1870 code and i replaced siliniod and transmission fluid and pan filter ,also changed throttle pisition sensor . what else could throw this code ? ...