Questions & Answers for: GMC Yukon trans module

...but will not shift again at about 30 to 35 mph. can it be true that my module is bad that shifts my trans from 2nd to 3rd gear? did you check the fuses some have a shift fuse ive seen them blow ...

2007 yukon gears seems striped or transmisson prob. only 72000 mi 2007 yukon will not start out in drive or 3. It starts out in 1st gear or 2nd gear not 3rd or drive. it will go in reverse. after ...

...to decrease a little bit. Any advice on what could be casuing this problem? these new veh. are electronicly controlled so you might have a module going out you wiil have to take it to a trans

How to replace the heater core in a 1998 gmc Yukon. Heater Core Removal & Installation To Remove: Disconnect the negative battery cable. Drain the coolant from the engine. Recover the refrigerant.

WHATS THE DIFFERENCE FROM THE 460LE TRANS FROM THE 480LE TRANS. HOW CAN U DETERMINE U HAVE THAT TRANS the tag on the trans will determine which one you have

i have a 1994 gmc yukon and im having trans issues just changed the trans pan and seal thinking dirty fluid. Well it manual shift 1-2 than over drive than it seems its over idling and like im in ...

you have to put in park by hand and no reverse, but all other gears. trans linkage out of adjustment .or lost gaer in trans replace or rebuild

Hi can someone tell me how to reset the this warning in my 2000 yukon (trans hot idle engine? My transmission was rebuilt 9/10/14 and sometimes I have this warning but transmission is new... thanks ...

...trans. Is ok Vacuum modulator is probably bad. A sticking shift solenoid inside the transmission will do it too. A bad transmission control module will cause it too. Your mechanic wasn't thorough ...

2008 GMC Yukon. Where is the OnStar module on it please? Replacing OnStar module. But no idea where it could be? The OnStar module on a 2008 GMC Yukon is located in the centre console, underneath the ...