Questions & Answers for: Remington track bar

Question about Electric Chain Saw

1 Answer

The chain on my Remington electric saw keeps jumping the sprocket. Solution? Thanks. Depending to what model you have, the Sprocket cover tab (located on the round part of the sprocket cover) isn?t ...

Ad

Question about 16" Electric Chain Saw

1 Answer

...the bottom. The "track" is called a bar. The bar is adjustable using an adjuster on the front of the side cover or papallel with the bat on the front or rear side. If you need more help, let me know. ...

Ad

remington 12 inch electric saw, chain came off, cannot find manual to put it back on. I am 73 and need to put the chain back on to cut up the pallets for heat. I need to put it on the right way. A ...

Question about 16" Electric Chain Saw Assembled 3.0 Peak

2 Answers

how do you replace the old chain with a new one? I need to replace the old chain with a new one I purchased but I don't know how. Wearing gloves is recommended. Loosen the bar slide it againt the ...

Where does the chain anchor at the base of the saw bar on the Remington Model 106890-02? There is no apparent slot aside from the one on the bar. It doesn't anchor it floats on a gear similar to this ...

Question about Electric Chain Saw

1 Answer

put chain back on Hi Eric, You will need a ratchet and the socket that fits the nuts holding the bar on. Also a screwdriver that matches the bar tensioning screw. The tensioning screw runs along the ...

chain fell off poll, trying to figure out how to put it back on. On the side of the saw where the bar (what the chain goes around/rides on) where it connects to the saw there are a couple nuts. Loosen

The chain came off. How do I put it back on? I do not have a user manual for it. Remove the drive end cover by removing the large nuts/bolts. Remove the bar and run the motor for a few moments, which ...

Question about Electric Chain Saw

1 Answer

How do i Tighten chain Jo: Unplug the saw. Lay the saw on it's side so the chain and bar are up (lay it on 4X4 blocks or something similar so the motor housing doesn't make the saw rock back and forth

Question about Electric Chain Saw

1 Answer

14SB REMMINGTON HOW TO REPLACE THE CHAIN Remove the cover, loosen the bolts to allow the bar to slide toward the sprocket. Lift chain off the sprocket and pull out from the notch in the bar. Be sure ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Remington Garden Experts

Jay Finke
Jay Finke

Level 3 Expert

1397 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

66846 Answers

Are you a Remington Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...