Questions & Answers for: Husqvarna track bar

...track slot. Adjust the bar to tighten the chain enough that the chain doesn't begin to droop from the bar, yet turn freely by hand. If no oil comes out of the port, then the oil lines or the oil pump ...

track around the whole bar. Use engine oil in the two small holes at the bar tip to lubricate the sprocket bearing. Back off the chain adjuster screw somewhat and reassemble everything--put the bar on

...track on the bar. It seems like thier are several links that will not ride in the chain track. The inside part of the chain are called drive links. I think when the chains came off the first time ...

...track on the bar. It seems like thier are several links that will not ride in the chain track. The inside part of the chain are called drive links. I think when the chains came off the first time ...

bring the jug to a power tool shop where they can "hone" your cylinder properly,..your on the right track with knowing the need to "scuff up" the cylinder, but it should be done with the proper honing

...and put it next to both sides of your bar and try to see if you see the bend. If the chain is still tracking ok than the bend may not be noticable by eye. A replacement bar can be purchased at Lowes ...

...bar/chain oil it started up after only 3 or 4 pulls and ran great! One day, after several weeks of use I gave the pull cord a yank to start up the saw. The saw started after the first or second pull ...

...bar and chain, and have been pointed to the sprocket maybe being the problem the sprocket has play on the shaft should there be and if so how much? If not could this be my problem and replacing the ...

...bar go off their track. The best remedy is to first disconnect the spark plug, then loosen the chain tensioner screw, and remove the two nuts holding the bar in place, then with a heavy glove on your ...

...bar/chain that ive drilled all the way thru to mount clamp with so it cant slip , but I will caution you , saws over 19 inches require a heavy hand to operate and will require a bit more strength of ...