Questions & Answers for: Chevrolet Monte Carlo tps sensor

Question about 2004 Monte Carlo

1 Answer

TPS Unit. On Some models it's the sensor in each wheel, on others it's the unit itself. I would go back to where you got the tires and have them reset it. If they don't know how, the easiest way to do

Ad

you even mention a heater core leak in regard to a transmission shift issue? You need to know what items determine shift stratagy to solve this. eg: TPS Sensor, Various Trans Sensors and Solenoids Etc

Ad

...TPS and it don't shift. Also changed the Speed sensor on trans.still don't shift The first thing to do is have the computer scanned for codes, these codes will tell you what system is not operating ...

...TPS (Throttle Position Sensor) Thank you for using fixya and good luck. WELL IF YOU SEE CHECK ENGINE LIGHT FLASHING CODE SCAN FOR TRANSMISSION FAULT CODES.IF YOU SEE NO CHECK ENGINE LIGHT ...

Question about 2004 Monte Carlo

1 Answer

...out.. Check fuel pressure with a gage. The TPS has to be set correctly to work right. May be a map sensor vacuum problem or crank sensor for a 1990 buick. What do you have as the header is

Question about 2004 Monte Carlo

1 Answer

Burning. A lot of gasoline That could be caused by clogged air or fuel filter. Cooling fans running all the time or a bad TPS sensor.

...sensor need to be replaced or is it something else? unless tps broke and has lodged / wedged 'paddle' NO. unplug it and start car see if it stops. it should set a check engine lite

...SENSOR (TPS) is usually located on the butterfly spindle so that it can directly monitor the position of the throttle valve butterfly.Throttle actuator control(TAC), that code comes from that part of ...

Question about 2002 Monte Carlo

1 Answer

...ITS WARMED UP sounds like you have a bad map sensor. Could also be your tps throttle position sensor but then you car would idle rough. I had a plugged catalytic convertor and it did the same

Question about 2005 Monte Carlo

1 Answer

...or mass air flow problems. TPS being "throttle position sensor" IAC being "idle air control" If a light is not currently present, listen under the hood for a hissing noise or signs of a vaccum

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...