...driver, carefully pry up on the trim around the gear selector (the side closest to the center console trim, not the aluminum looking plastic directly around the selector). Underneath there are four ...
...torx 25 screws, pull the liner to the rear and you can see it right there above the liner. To remove the siren module...it uses a sheer bolt, which unfortunately you'd need to either drill it out, or ...
driver off and gently push up, it should just pop out. 2. Simple cover that can be separated with a bone tool or similar so you don't chip the cover piece. Behind that you will find two Torx 25 screws
...center of the vehicle. This is so you do not blind oncoming cars. The screw heads could be hex or torx or
driver. After removing the 2 bolts on the bumper cover, you may open the hood and remove the plastic fasteners on the top of the bumper. To remove the plastic fastener, simply depress the center until
driver door of a 2012 volvo s60 On a S60, 2012, (drivers door) you first remove the plastic cover in under which you find the lock (with keyhole). secondly, open the door and remove the 15 mm diameter
Question about 2002 S60
...Driver Information Module - Volvospeak for "instrument cluster") where they started acting up and finally quit working. You can get an ebay or junk yard unit, but you don't know when that will start ...
Usually answered in minutes!
567 Questions
492 Questions
251 Questions
180 Questions
122 Questions