Questions & Answers for: Volvo torx driver

...advance. IT IS LOCATED ON THE BACK OF ENGINE ON DRIVERS SIDE NEAR O2 SENSOR NEAR EXHAUST AND HAS 2 TORX SCREWS THAT HOLD IT IN PLACE NEAR ENGINE BRACKET ON T-5 2.3 TURBO it is located on the drivers ...

...torx 25 screws, pull the liner to the rear and you can see it right there above the liner. To remove the siren module...it uses a sheer bolt, which unfortunately you'd need to either drill it out, or ...

...the black cover that says Volvo just behind your oil filler cap. It is held in place by 8 #30 Torx screws. The petrol filter is underneath the car, just forward of the rear tire on the ...

...of these the other day. Its fuse number 11, inside the car over the drivers foot. You will need a torx 25 screwdriver to remove the lower dash panel (2 screws) and then when you look towards the ...

...driver side door will not latch closed... THE DOOR CATCH MUST BE REPLACED. THIS IS DONE BY REMOVING THE INSIDE PANEL AND REMOVING THE THREE TORX BIT BOLTS FROM THE OUTSIDE OF THE DOOR THAT HOLD THE ...

...near rearview mirror. Then use a torx driver to remove two small screws holding bezel in place. After that, remove the bezel. Now you can access the the two torx screws holding mirror. Best of

...driver door won't open from outside or inside I am working on this RIGHT NOW.  Remove panel (see Utube) remove white cover (Torx 25) from interior of exterior handle.  You will see ...

driver door of a 2012 volvo s60 On a S60, 2012, (drivers door) you first remove the plastic cover in under which you find the lock (with keyhole). secondly, open the door and remove the 15 mm diameter

these startop screws that hold the plate th 2.4 L, 5 Cylinder, Non-Turbo Any Hardware Store carries Torx Drivers. Harbor Freight is a good inexpensive source

Volvo S60 driver's seat belt Need to purchase the correct torx head There are plenty of online stores where you can buy Torx bits as a set to cover all the sizes you could need.