Questions & Answers for: Honda torque wrench Cars & Trucks

Ad

Question about 2004 Odyssey

2 Answers

torque wrench. When using a preset-type torque wrench, be sure to tighten slowly and not to overtighten. If a bolt makes any noise while you are torquing it, loosen the bolt, and retighten it from the

Ad

take of escape? buy pan and gasket, follow directions on gasket instructions on whether or not to use sealant. Call the dealer for bolt torque. If you don't have a torque wrench, take it in for repair

Ad

Question about 2006 CR-V

1 Answer

29 ft lbs with a good and accurate torque wrench, then tighten them further in two steps 90 Degrees per step. But if you've replaced the head bolts with new ones tighten them and additional 90 Degrees

Question about 1991 Accord

1 Answer

...torque wrench for the crank shaft pulley bolt it has 225lbs.of torque or more.I just did one on my 1991 honda accord dx .you have to take off a/c belt ,alternator etc. on the crank pulley.(I took it ...

Question about 1991 Accord

1 Answer

torque to the bolt with an impact wrench. Start the air compressor by plugging it in and turn it on. Set the pressure of the compressor on the highest setting. Attach air hose on the air compressor to

...torque wrench and just nip it up with a ring spanner and a two finger pull this will give it about 15lb which is about right ,you cannot do this sort of thing with a torque wrench as the threads can ...

renault scenic 1.4 16v torque wrench setting for head bolt 1.4 16V K4J torque wrench setting for head bolt

Question about 1990 Civic

1 Answer

...torque wrench ? or engine power HP and Torque specs.? if latter google answers this , in 1sec.flat. google is your friend...?. this post was ignored, IMO, because no year, or engine options

Question about 2005 Civic

1 Answer

on the threads, screw them in by hand to ensure they are not cross threaded, then if you are using an inch lb torque wrench it will be 156 inch lbs. or if a ft lb torque wrench would be 15-16 foot lbs

...get tight use the ratchet to add about half a turn. **NOTE** As soon as you feel resistance STOP!!** At this point use the torque wrench at the lower setting and you should be near the correct

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

1992 Honda Accord
1992 Honda Accord

2,991 Questions

1991 Honda Accord
1991 Honda Accord

2,683 Questions

1995 Honda Accord
1995 Honda Accord

1,633 Questions

1996 Honda Accord
1996 Honda Accord

1,634 Questions

1998 Honda Accord
1998 Honda Accord

1,569 Questions

Manuals & User Guides

Loading...