Questions & Answers for: Nissan torque converter

Question about 1989 Hardbody King

1 Answer

...torque converter is good and all but when i go and tighten the bolts to the transmission the egien locks what could it be at first we thought it was the spline didnt go in the torque converter but we ...

Ad

Question about 1989 Hardbody King

1 Answer

WHEN i PUT THE CAR IN GEAR IT JUMPS WHY? Idle speed too high or torque converter sprag is locked up.:-( The torque converter is on the front of the trans

Ad

Question about 1996 200SX

2 Answers

...TORQUE CONVERTER CLUTCH" this is part of the torque converter of thetransmission and is controlled by an electric solenoid inside the transmission pan attached to the trans valve body. torque ...

is making a noise in the tranmision.and theirs oil leaking.could it be the torque converter YEP TORQUE CONVERTER WILL LEAK AT SEAL AND MAKE NOISE.ALSO TRANSMISSION OIL PUMP MAKE NOISE IF ITS GOING BAD

Question about 2001 Xterra

1 Answer

...torque converter be seperated from the flex plate or doest the torque converted come out with the engine? Must unbolt the converter from flex plate or you could damage flex plate and bushing in ...

Question about 2005 Terrano 2.7

1 Answer

...torque converter model td27 got damage You will need to have the transmission removed to access the torque converter. A new torque converter should fix things unless debris from the damage has spread ...

...torque converter on a 99 Nissan quest Where is the torque converter? Transmission installed in car? If so there is often an access plate on the bottom of the bell housing to get the bolts off with an ...

...Torque Converter Clutch Solenoid Circuit Fault Possible causes Low transmission fluid level Dirty transmission fluid Faulty torque converter clutch solenoid valve Torque converter clutch solenoid ...

torque converter on a 2006 nissan altima 2.5 automatic transmission If the transmission is out of the car, the flex plate is bolted to the engine's crankshaft and torqued/locked as necessary. Then you

Question about 1999 Quest

1 Answer

...TORQUE CONVERTER FAULT.. and goes in to limp mode and won't go over 20 mph.. then goes back to normal after about 10miniutes.. do I need a torque converter? Check the torque converter lock solenoid. ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2005 Nissan Altima
2005 Nissan Altima

1,587 Questions

2003 Nissan Altima
2003 Nissan Altima

1,450 Questions

2000 Nissan Maxima
2000 Nissan Maxima

1,309 Questions

1995 Nissan Maxima
1995 Nissan Maxima

1,122 Questions

2002 Nissan Altima
2002 Nissan Altima

1,306 Questions

Top Nissan Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...