Questions & Answers for: Miller torch

Welding Question what is the differance between a welding torch and a plasma cutter? The plasma also cuts ferrous and non-ferrous metals much faster than an Oxy-Fuel torch or abrasive saws, with low ...

...interface to the remote control. Regards, Carl re expressmetal problem try welding with a diferent torch or some stick welding leads could be a problem with the tig torch power cable ( is it at

motor not feeding wire Had a similar problem. The tube at the torch came loose and wire jammed at the torch. If motor is turning, check for this.

...trigger no worky gun trigger no work when i pull it, power is on, but motor not spinning Remove the torch and check for continuety, if it is the switch youcan purchace a new one from the torch ...

...strike the arc. The hose is not obstucted. The manual doesn't mention this problem. Remove the tig torch twist lock from the front of the machine. Step on the pedal as if you were striking an arc

...continuous and a 9 second post flow with 5356 crown weldind rod. if you have a gas cutting torch smudge the aluminum with acetyline fume from just acetylene burning in the torch. then

i bought an older syncrowave 250 i dont know where the torch is connected and there it doest spark Torch goes to ground side where gas will flow out of it. Use a tig torch 17 if water cooling is not ...

...with eart direct to material it will only scar the 8mm plate not cut . This is using a new machine torch on a torchmate 4x4 although hand held torch cuts fine . Any ideas? Check the voltage at the ...

installing tig torch to water cooler You can directly connect your water cooling argon torch to the tank, but the pump electric wires must be connected in accordance to the switch, when you press the ...

Regulator set at 50psi. Power light ON. Ready light ON. All Trouble lights OFF. Fan motor running. Torch tip is clean, with new electrode, tip, and shield cup installed. Pressing torch switch, I hear