...microwave hood combo How can we install it, the holes used to mount the microwave are covered by the plate the plate goes on the backsplash and two holes on top go inside cabinet that you have to ...
Question about KSM150PS Artisan Series Stand Mixer
...plate: If you turn the top screws one quarter turn, both equally then test the mixer it should adjust the speed. Please make sure not to over tighten or loosen these screws as it can damage the speed ...
plate and then you'll see four screws (two on each side) holding on the top cover for the mixer. Remove the four screws and then lift off the top cover and you'll see the motor, circuit board and gear
Question about KP2671 Professional 6 Series Stand Mixer
...top plate, but the whole head was wobbly. I fixed it by removing the top plate, then locating the three screws that hold the top to the base. These screws are under the motor. I had ...
...top of nontrol plate has only two wires from it out either side a flat cardboard tube. If shorted you will lose all speed adjustment. Test by disconnecting one or both wires.DO NOT RUN MIXER WITHOUR ...
Question about KSM150PS Artisan Series Stand Mixer
...plate. There are 3 screws on this, two at the top, one on the bottom. Try adjusting the top two screws, to adjust, turn in the control plate adjusting the screws an equal amount. Also check to see if ...
top side screws, loosen the middle and lower side screws as needed. Separate the washer door face wide enough to remove the user control board, let it hang by the cord. The handle will be loose in the
Question about K5SS Mixer Speed Control Plate Kitchen Aid
...top and undo them. Fit the new plate, each screw 8 turns in to start with. Hook up the spring, put on the wires where they came from. Start machine on speed one, and adjust the top screws evenly to ...
Question about Kitchen Aid KSM150 Artisan 5 Quart Stand Mixer
...plate's top screws turned completely clockwise, Off is truly Off. A half turn counterclockwise is where Off become On. Doing several full turns counterclockwise does not particularly alter that. ...
top or the bottom of your control plate or the phase board. Start point for the top screws is 8 full turns in from being not even in the hole (both sides) and on speed 1 the bottom screw does not even
Usually answered in minutes!
258 Questions
74 Questions
77 Questions
63 Questions
47 Questions