Questions & Answers for: Chevrolet Chevy top mark

Question about Chevrolet Chevy

3 Answers

...top dead center, TDC, when it is TDC check to make sure the timing mark on the harmonic balancer is on the zero mark, look back at the rotor, it should be be facing somewhat forwrd to the motor. That ...

Ad

top and was pushing the straw out but now the mark on the pulley is nowhere near where it is supposed to be. Am i doing it wrong? or can the mark on the crankshaft pulley be wrong? yes it can be wrong

Ad

Question about 1985 Chevy

2 Answers

top and was pushing the straw out but now the mark on the pulley is nowhere near where it is supposed to be. Am i doing it wrong? or can the mark on the crankshaft pulley be wrong? The truck was timed

less likely to mark the piston top. Never turn the engine by any means besides normal hand/wench method and never force anything. The entire operation actually takes longer to write than it does to do

Question about 1983 Chevy

2 Answers

...timing to the cam to the crankshaft is on a 1983 454 Chevy engine. 8 degrees before tdc crank timing mark at top center, cam mark top center will be TDC No.1, cam mark pointing to crank mark TDC No. ...

...top dead center, mark the distributor where the #1 spark plug cable is, pull the cap off and turn the distributor until the mark is aligned with the rotor contact. Replace the cap and try starting it ...

Question about 1986 Chevy

1 Answer

...mark. is the crank and cam aligned and the motor #1 cylinder on top dead center? Slide balancer on crank then all you do is put the new mark on the balancer at the new timing chain cover 0 mark. Or ...

Question about 1986 Chevy

1 Answer

...Top Dead Center. #1-3-5-7 is the driver's side front to back and 2-4-6-8 is passenger side front to back. As the timing mark on the bottom pulley nears the 0 mark on the timing tab the valves on #1 ...

Question about 1986 Chevy

2 Answers

...Remove #1 spark plug ( front left ) stuff shop rage in spark plug whole. use screw driver to helt stop up hole just bump starter a few times till you hear a POP that will be top dead center #1 check ...

...out I will need to replace the gears. I have no idea how to figure out when #1 cylinder is at top dead center for the enitial timing.I am working on a 1999 chevy vortec 5.7 liter. I need the ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...