...FOR DIAGNOSTIC TROUBLE CODES..YOU MAY HAVE ONE OF THE WHEEL SPEED SENSORS LOSING SIGNAL OR A CRACKED TONE RING ON A FRONT AXLE OR A BROKEN/CORRODED WIRE..THESE CODES SHOULD LEAD TO SOURCE OF ...
wheel speed sensor wiring harness, faulty hydraulic unit, fault electronic brake control module(EBCM), faulty tone ring,etc. There isnt a relay or reset procedure to turn the light off- it can only be
...300 Big v6 3.5 i think CRANKSHAFT AND CAMSHAFT TIMING MISALIGNMENT.POSSIBLE TONE WHEEL OR PULSE WHEEL IS DAMAGED OR CONTAIN DEBRIS,CKP OR CMP SENSOR HARNESS OR CONNECTOR HAS FAILED OR PCM HAS
...TONE WHEEL FLEX PLATE IS DAMAGED, TONE WHEEL PULSE RING MAY BE DAMAGED, ERRATIC CKP SENSOR SIGNALS WIRING CONNECTOR PROBLEM, CKP SENSOR HAS FAILED, PCM HAS FAILED. this is an obd2 trouble code table, ...
...Tone wheel or pulse ring is damaged .Trouble Code: P1899A/T Park Neutral Switch Stuck in Park Position or In Gear Possible Causes:P/N switch signal circuit is open between the switch and PCM .P/N ...
...to the four speed sensors for each wheel for cracked or broken wires. If the light comes on after you start driving than check the tone rings on the drive axles for cracks. Let me know what you
...Tone wheel/pulse ring is damaged or corroded.CMP Sensor has failed.CMP Sensor signal circuit is open, shorted to ground or battery. voltage or 5v supply.CMP Sensor ground circuit is open.PCM has ...
speed sensor output t&c REAR TONE WHEEL HAS SENSOR
...tone wheel is broken any where this will produce a fault or failure, if the sensor fails same result.a scanner can read this signal if the sensor can produce it other wise you may have a open circuit ...
Question about 2006 PT Cruiser
...TONE WHEEL/PULSE RING ERRATIC CRANKSHAFT POSITION SENSOR SIGNAL CRANKSHAFT POSITION SENSOR TONE WHEEL/PULSE RING CAMSHAFT POSITION SENSOR CRANKSHAFT POSITION SENSOR Always perform the Pre-Diagnostic ...
Usually answered in minutes!
1,229 Questions
1,289 Questions
1,198 Questions
1,079 Questions
1,173 Questions