timming problems I have a 96 rodeo when i got the truck i put a head gasket on how do i put the timming belt on the cam pulley the belt was off of it when i got it 4 cylinder or v-6? Try and get the ...
trouble getting marks aligned on 2001 Izusu Rodeo I replaced the water pump and tining belt on 01 Izusu Rodeo and the timing marks "by the book" do not seem to be right...help if its a 6VE1 engine you
...timming mark diagram from you.The vehicle is Isuzu rodeo 3.2 DOHC 24valve 1998 I dont know how many times you tried turning it over with it being out of timing but to many times will kill the ...
...heads suggest remove rocker covers and make sure cam lobes are in this possition as well as all other timming marks luckily these engines (V6) are free wheeling (wont bend valves) set up like pic ...
...1984 nissan pick-up just put back together timings off how to set? is there any way to put and set timming chain back on after I have droped it and lost the ...
marks on the pulleys are supposed to line up with the covers and the camshaft is supposed to line up with the oil pan mark ( no.2 piston all the way up to the top ) but it still doesnt work. what am i
...marks on isuzu trooper 2001 3,0 dohc engine the timming gear that the belt runs on has a mark (V cut in gear) to rear cover at about 12 o clock and crank pulley has timming mark for top dead centre, ...
...belt of isuzu 4jx1 before you remove belt time mark on cam gear as well as crankshaft pulley, the timming mark on the pump drive gear (lower gear in this picture) will not line up but thats ok line ...
Question about 1995 Rodeo
...timming marks on the cam shaft and watever the gear is to the left o the crankshaft. Its on a 1995 Isuzu Rodeo 4 cyl 2.3 also need to know how to get it back timed cant seem to find marks The best ...
How do i mark Isuzu timming marks? How do i mark Isuzu timming marks on 250 paintstik or welders chalk or soapstone
Usually answered in minutes!
832 Questions
814 Questions
819 Questions
720 Questions
623 Questions