...timing marks again. (this process is much easier done with the plugs removed.) If everything is still lined up correctly (crank at TDC and cam pulleys pointing to each designated mark on the covers.) ...
Valiant 1963, was running ok but after I took out three spacers of the sparks did not run any more, Now I forgot the position of these 3 spacers. it's not the spark plug spacers for you probably did ...
...timing marks should be when in time on a 93plymouth acclaim 2.5 Twelve (12) degrees. But special procedures are required to set the timing. Refer to the emissions label that should be under the hood ...
...timing marks on overhead cams and crank.If none, make some. 14. Ease pressure off timing belt tensioner 15. Remove belt and replace with new. Trick here is to make sure you get the belt notches lined ...
...timing marks on overhead cams and crank.If none, make some. 16. Ease pressure off timing belt tensioner 17. Remove belt and replace with new. Trick here is to make sure you get the belt notches lined ...
timing marks cant find the timing marks on a 1990 acllaim 2.5 4 cylender Look for little window (opening ) on transmission near where it bolts to engine. Marks will be there, and other is on your ...
...timing marks so it will be in time? the distributor rotor should be pointed towards the #1 plug wire on the distributor cap.mark on the distributor housing where the rotor is pointing.put the ...
timing belt broke on 2.5 liter Acclaim. Replacing, but, where are the alignment marks? Thanks! # 1 cylinder at TDC. Crank sprocket and intermediate shaft mark align, crank at top, intermediate at ...
...timing on a '92 Plymouth acclaim, you can get the piston #1 on TDC but how to tell if the valves are correctly lined up? The alignment marks on the cam gear will tell you that. You did not mention ...
Usually answered in minutes!
171 Questions
146 Questions
133 Questions
98 Questions
69 Questions