Questions & Answers for: Hyundai Accent timing marks

timing marks I'm not familiar with your car although most have inscribed marks on the crankshaft pully and then on the block itself and may be graduated and marked with different degrees of advance or

...timing mark, put piston number one should top dead center look cranshaft mark.when you done. second step is to set up camshaft check timing mark on the camshaft follow the marks fisr

timing marks on 2001 Hyundai Accent the timing marks are as follows... the camshaft gear mark will be roughly in the 4 o clock position... the mark on the gear needs to line up with a small pointer on

...timing marks Ok, so just get the timing from the label under the hood on the white label and then use a timing light and shine it on the timing marks to read the timing. It helps to put a while chalk ...

timing belt marks on a hyundai 1994 excel g4ek motor timing belt marks .I have replaced a recon head and i have no compression i first want to make sure the marks are all ok .can i get the correct ...

...timing marks 1st you may want make sure that's not an interference engine. if it is then chances are the valves are bend in the head. changing the timing belt probably won't help then. If its not an ...

...timing marks on 1300cc engine where are the timing marks on 1300cc engine ignition timing marks are notch on crankshaft pully and marks on timing cover, but is controled by ECU and is not adjustable, ...

...timing marks for 2002 hyandai accent 1.6 The timing marks allow the engine to be correctly timed . It depends on what you are trying to do . If you are just trying to time the engine with a timing ...

...timing marks diagram for a 2002 hyundai accent gl Hello tazzie13101, Below is an image showing the timing marks. I circled the detail for the hole in the cam sprocket, you will look through the hole ...

timing marks on the cam gears and somewhere close to those look for the alignment marks (maybe notch marks, holes or indented match marks). (Some manufactures use the machined gasket surface where the