Questions & Answers for: Isuzu timing marks

Question about 2000 Trooper

Timing for tropper 6cly and 4 camshafts and 24 valves model 2000

...timing marks are aligned, No.2 piston will be on Top Dead Center. 014RW003 Legend (1) Alignment Mark on Oil Pump (2) Groove on Crankshaft Timing Pulley (3) Alignment Mark on Crankshaft Timing Pulley ...

Question about 1997 Rodeo

2 Answers

Timing belt alignment

...timing marks on the camshaft sprockets and crankshaft are aligned with their corresponding stationary marks. The 0 degree mark on the lower timing belt cover is the timing mark for the crankshaft ...

Question about 2000 Rodeo

2 Answers

Won't start after timing belt has been replaced

...cover back plate at those two spots, those will be the timing marks. You will notice the cams dont spring into those positions on every turn, that means they are not on the right stroke to set

Question about 1995 Pickup

2 Answers

I can't find the timing marks of an isuzu engine

...timing marks of an isuzu engine 4hf1 Timing is aligned with bolts through holes in the drive wheels under the timing cover and a mark on the crankshaft remove the timing cover turn the crankshaft ...

Question about 1999 Rodeo

2 Answers

Replace timing belt holden vectra 2.2ltre

...marks timing cover has marks on it,line it up with pulley,remove pulley and cover,check to see if any marks on camshaft.un do tensioner.to be sure make your own marks how we do space teath of timing ...

Question about 1996 Rodeo

1 Answer

I need to know where the timing marks are on a 96

...timing marks are on a 96 4wd isuzu rodeo. CAN ANYBODY HELP ME PLEASE? I hope you get this, I was going to go to bed until I noticed how bad you were needing some timing marks :) Injection pump and ...

Question about 1995 Rodeo

1 Answer

1995 2.3L 4W ISUZU RODEO HOW DO YOU GET IT BACK IN TIME

...Re-check the timing marks on the crankshaft and camshaft. Re-install the timing belt cover and everything else you took off to get to the belt. Be sure to torque the crankshaft pulley bolt to

Question about 1999 Rodeo

1 Answer

On a 1999 Isuzu Rodeo 3.2 V6 DOHC If you put all timing marks together on engine and then put timing belt mark all together on the engine and rotate two rounds with crankshaft does all the marks come

...timing marks together on engine and then put timing belt mark all together on the engine and rotate two rounds with crankshaft does all the marks come back together on the engine and timing belt or ...

Question about 1999 Rodeo

1 Answer

Do I rotate the crank timing mark back to alignment when installing the new belt or put it on where it sits?

...and oil pump mark is off slightly;Vehicle ran prior to disassembly. ALL Timing marks should be lined up correctly. If they are out of position you could do some VERY expensive damage to the

Question about 1999 Rodeo

1 Answer

2002 Isuzu Rodeo 6VD1 DOHC. Timing marks don't line up!

...Timing marks don't line up! Can't get the passenger side cam marks to come into line when all the other marks line up including the timing belt marks they line up. It's just the passenger side cam ...