Question about Ultimate Care II LSQ9549L Top Load Washer
...clicking/tapping sound, wouldn't drain & wouldn't spin. check the lid switch operation,not sure what the noise could be maybe somthing stuck in the pump? hope ths helps unless the contacts in the ...
...sound. thought it might need some rinse aid but doesnt work! It sounds as if your motor is locking up. Check under the front lower panel, snd see if there is water leaking into the motor, the motor ...
Question about Ultimate Care II LSQ9549L Top Load Washer
...clicking sound when opening or closing the lid. This happens on the 3 different wash cycles [ regular, casual permanent press and hand washables ]. Is the control timer at fault? I would start with a ...
...clicking from the timer 'area' on the console. I would only guess that it is the timer due to the fact that I just had the transmission and gears worked on about 7 months ago.I'm taking the timer in ...
...timer clicking and advancing, if I push in the knob and advance it, agitation won't start. Sounds like you may a bad lid switch. Do you hear any clicking noise when the lid gets shut. The clicking ...
...the clicking sound....thanks HOPE THIS WORK, DON'T FORGET TO RATE ME Timer is fried. Washer went off-balance and tripped the off-balance switch. DIFFERENT REASONS WHY MY WHIRLPOOL WASHER DOES NOT ...
Question about Ultimate Care II LSQ9549L Top Load Washer
Whirlpool top load LSQ9549L stops working at rinse cycle Washer will fill and agitate, stops working at rinse cycle and will not spin either. Knob makes clicking noises only. sounds like your lid ...
whirlpool washer bad timer Washer appears to operate normally, but midway through the wash cycle it just stops. The timer clicks and buzzes some, and then stops all together. It does it in all cycles.
Question about Ultimate Care II LSQ9549L Top Load Washer
timer,open the lid and stick a screw driver into the hole where the plastic acuator on the lid goes into the hole and push down easily and see if washer will run this is where the lid switch is and it
Question about WTW4950XW Washer
clicking noise here n there. should I just dump it? Or fix the actuator? Sounds like the timer is acting up and not moving cycles. The part can be looked up and explained how to install it by checking
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions