Questions & Answers for: how to get time to show up Ovens

...TIME button again. The display will show "no Shdn" for no shut off. 3. Press the START button. The control is automatically set to turn off the oven after 12 hours baking or 3 hours broiling should ...

...start. I get a "Door" message when I try to start it. The Message only shows when I try to set the time with one of the function buttons, like Defrost times. If I just try to start it with the Start ...

How to set the timer Unfortunately, I have lost the instruction maual and cannot work out how to to set the timer on this oven. Can anyone help 1. Set the oven to the required temperature. 2. Press ...

...press and hold CLOCK for 5 seconds. To display the clock time again, press and hold CLOCK for 5 seconds and the time of day will show on the display. The clock time should not have to be

My zanussi ZBS773 wont switch on, the clock is showing and the wrong time and the decimal points are flashing, not sure if this is something to do with the timer, but that is showing 0.00. Not sure ...

...duo Tried to auto-clean two days ago. Did not clean. Oven locked but didn't clean. Had hard time getting "locked"(from below the clock numbers) off display panel. Tried auto-clean again. Did ...

...show ready on the screan. If the temperature reached at it operating temperature and oven display doesn't showing how much time left for ready screen then most probably its IO board gone. I have seen ...

time show and not the temperature? When I turn the oven on and then turn the thermostat knob to select the temperature the control panel still shows the time and not the temperature....why is this? It

...show correct time but changing every 2 sec and oven not working. I was told one botton was pressed for a long time when setting the time Sounds like a great story... (I doubt it... though) I'm ...

...show correct time but changing every 2 sec and oven not working. it is said that someone pressed one of the clock setting buttons for a long time perhaps the manufacturer's website and tech support ...