...tines 18in. width 5.5 hp. Briggs & Stratton OHV and it's also a rear tine tiller. You can get back with me at : [email protected] soon I hope. the tines are usually connected with shear bolts ...
troy bilt pony left side tine assembly fell off troy built pony left side tine assembly fell off shaft....after replacing broken bolt left side tine assembly wobbles...help sounds like the shaft is ...
Question about 8.50 Torque Rating Rear Tine Tiller
...tiller, model 917.299080. Used it about 30 minutes and the tines stopped moving. Checked the belt and pullies, all seem to be fine. Did not hit any objects, ground very soft. What other areas do I ...
Question about 8.50 Torque Rating Rear Tine Tiller
rear tiller won't go into gear.belt needs replacing craftsman 6.5 real tine tiller. how do you replace belt find your model number from the list on this link and click to get your manual ...
...TINES OFF THE TILLER. THEY MAY GIVE YOU A HARD TIME GETTING THEM OFF SO DON'T GIVE UP. ONCE YOU GET THE TINES OFF YOU SHOULD SEE THE SEALS YOU CAN POP THE OLD ONES OUT WITH A SCREW DRIVER CLEAN OUT ...
Question about 8.50 Torque Rating Rear Tine Tiller
...tiller that has sat unused for 4 years. I replaced the engine and while in goes forward and backward, when I engage the tines they won't rotate and the engine bogs down... how do I un-seize ...
tines on tiller I have a 17in craftman rear tine tiller and the tines will not turn...why..Craftman 17in Model 917-294271 -Check the locking bolt that hold the tine shaft to the main shaft. Possibly ...
Question about 17 In. Dual Rear Tine Tiller
...tiller up and examine the tines for obstacle such as a rock. If there is nothing jammed try to turn the tines by hand. If the they turn freely you most likely broke a shear pin that secures the tines ...
...tines You have not shared which model and make of tiller you have, but many of them have a set screw or two holding each tine on. You would need to loosen the screws, and maybe polish the shaft with ...
Tiller tines don't turn when I throttle? I replaced the carb and when I started the tiller, the tines were turning fast. I think the throttle cable wasn't connected. After connecting it, now they ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions