Question about Copper Corrugated Water Heater Connectors Box 12
...leaks at cold inlet . The pipe has a washer and I didnot use pipe dope or tape should I ? How tight does this need to be? pipe dope not needed tighten snug then one quarter turn is recommended ...
Question about Copper Corrugated Water Heater Connectors Box 12
...connection is leaking. The nipple threads are teflon wrapped and the flexible connector nut is tight but there is a slow ooze. Is the flexible connector washer replaceable? Yes. If the nut is
Question about Copper Corrugated Water Heater Connectors Box 12
chain it tight, then you will retighten the screws or nuts to lock the bar and chain in place. Be sure you lube the chain and bar with "Bar Oil" before starting to put the saw into service. Good Luck.
Question about Copper Corrugated Water Heater Connectors Box 12
I have an older poulan superwoodsman 1800. Chain does not rotate around the bar. Is there a chain brake on this model if it has its a big handel and you would see it, try turning the blade by hand it ...
Question about Copper Corrugated Water Heater Connectors Box 12
...gas line? you must loosen the connection at the water heater until you smell gas coming out, then tighten. wait at least 5 minutes before attempting to light. this will give time for the gas to ...
Have to hold the flush bar down and the water does not take out all the paper & etc. I'm assuming this is a question about a toilet not a water heater as its listed , if so,, remove the lid to
Question about Copper Corrugated Water Heater Connectors Box 12
can't remove heating element because of tight space can't remove heating element because of tight space Suggest disconnecting water supply / inlet & outlet. Drain tank using ...
Question about Copper Corrugated Water Heater Connectors Box 12
...2) New thermocouple was screwed too tight? finger-tight + 1/4 ...
Question about Copper Corrugated Water Heater Connectors Box 12
Where can I get a replacement heating element? I don't see a make or model but these are available on line and probably at chain hardware stores too. Expect $12-$20 US and you will need to shut off ...
Question about Copper Corrugated Water Heater Connectors Box 12
...wrench in the body if the gas valve?? And I've threaded it on and threaded it in and can't get it tight enough facing forward So the dials are Ccessibke You will have to hold the body to get the ...
Usually answered in minutes!
335 Questions
282 Questions
267 Questions
250 Questions
267 Questions