Questions & Answers for: tight chain

Ad

Question about 2007 CRM F450RR I

1 Answer

chain tight spot got crm f450rr Correct slack is approx 15-20mm BUT adjusted like that there's a tight spot with 0mm. The green new chain required gauge on swinging arm tells me there's plenty of life

Ad

Question about 2007 CRM F450RR I

1 Answer

...chain isn't tight enough, Not that it should be tight but with a gentle pull away from the guide bar the "roots" of the chain should not come clear of the groove in the bar. The chain should not be ...

Ad

if it is keeping the chain tight and not moving even though it is tight, if it loosens, replace the tensioner. Check the chain for any broken or worn spots or links, if any are found replace the chain

Question about Pro Chain Saw 46cc 20"

1 Answer

tight Is the chain being properly oiled? Make sure the cover fasteners are tight after adjustment. If the chain is dull or is improperly sharpened, it will heat badly causing the chain to become loose

Question about Pro Chain Saw 46cc 20"

2 Answers

...It could be that the bar is not lined up with the saw and the chain is not in line or the chain is not tight enough , tou should be able to pull the chain up off of the bar by about 3 to 4 ml

Question about 1987 FZR 1000

1 Answer

chain too tight can destroy your output shaft bearing. It's only about $30 or so for a new one but your engine needs to be completely stripped down to replace it, it's not a fun job. I have seen a lot

Question about ZR10580 FactoryReconditioned 42cc 18" Gas Chain Saw

1 Answer

TIGHT THE CHAIN PLATE.UN TIGHT IT AND PULL THE CHAIN PLATE TO THE FRONT UNTIL IS STRETCH.BE AWARE THAT TO MUCH TENSION WILL NOT WORK SO LEAVE A GAP OF 1/4 INCH BETWEEN THE CHAIN AND THE PLATE.TIGHT IT

Question about Windwood 26 Men s Cruiser Bicycle

1 Answer

...tight chain the rear axle nuts adjust the alignment of the wheel to the frame. You know you have it right if both the chain is tight and the tire closest to the crank is centered in the frame. The ...

Question about Windwood 26 Men s Cruiser Bicycle

3 Answers

...to tight the chain(viewing from back side of vechicle) and vice-versa, also give clearance to the thumb.thereafter tight the axle bolt.remember while tighting make sure that wheel rotate freely

...chain tight. you tighten chain rev. engine chain will just about come okk -tighten chain rev. engine same thing. you have to use the tension screw to move the cutter bar to tighten the chain then you ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Motorcycles Experts

Arnie Burke
Arnie Burke

Level 3 Expert

6480 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

Muntejaya Ginting
Muntejaya Ginting

Level 3 Expert

10422 Answers

Are you a Motorcycles Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...