Questions & Answers for: throttle sync

Throttle bodies can't be sync'd because of worn linkage see pic. I have looked around and haven't read of this happening often. Sounds like a rare problem. Anyone know of this happening? I can get the

Throttle bodies can't be sync'd because of worn linkage see pic. I have looked around and haven't read of this happening often. Sounds like a rare problem. Anyone know of this happening? I can get the

throttle body adjustment to sync? If not, What do I use? Here is a diagram showing the tubes you connect your vacuum gauges to. http://216.37.204.203/Yamaha_OEM/YamahaMC.asp?Type=13&A=326&B=11

...rebuilding the carbs on my mercury 30 hp 4 stroke enginge, it falls off on acceleration between 1/3 throttle and 3/4 throttle Check your "sync n link" of the throttle pick up and the ignition

It idles but when I pressthe throttle it kills out throttle safety switch little pin switch behind the thumb throttle hold it back bet it will let u open throttle..could be bad switch or carbs out of ...

...when foot to the floor on the throttle revs up then down by itself even when foot to the floor on the throttle but idles real good Sounds like the throttle position sensor is out of sync or gone

...when the sync is on the port motor will hunt constantly at a low idle. when the sync is off the throttles are not matching up. needs to be resyncronised on a computor by dealer

...this is a fairly common failure of the TPS to sync with the throttle pedal sensor, and often caused by something as simple as crud building up on the throttle body plate keeping it from fully

...car, gas pedal may have failed or not be in sync with throttle. This can happen when throttle gets dirty and sticks part way open. If not FBW car, insure gas pedal is operating throttle body

...throttle cable to sync carbs up really close 96 xlt 600 snowmobile buddy took his carbs apart with no knowledge gave me parts to put back together I no my sleds this is just f:/cin with me on carb ...